![]() I then thought I would see if the Houselinc synchronizing command would have the same effect - but I found that this particular light device (Living room) was not programmed in Houselinc. Each time I ran this command for the lights in question - they flickered in time with the signals of the LED on the light switch. ![]() This was done by using a Homeseer command to "Read device links and settings". Today I noticed that the flicking lights appeared to be related to the Insteon signals being transmitted on and manged to be able to reproduce the flicking at will. I have a Insteon Hub and a PC running Homeseer which basically runs the house and Insteon Houselinc which is no longer used as it doesn't do conditions as well as HS. My setup consists of approx 20 Insteon light switch devices & 10 older x10 devices (mainly motion sensors). I tried replacing the 2477D device with no success, Also tried reducing the load by reducing the number of lights as well as replacing the downlight transformers with expensive "high quality" ones. It seem to mainly be one set of lights (Living room). For a number of years I have had the issue of my halogen lights flickering.
0 Comments
Leave a Reply. |